Amigurumi Rose the Rabbit Free Pattern
Hello dear Amigurumi Followers
Today we share one free amigurumi crochet pattern again for you. As you know we share new amigurumi free patterns every day. The main crochets are amigurumi gazelles, amigurumi bears, amigurumi pola, amigurumi pandas, amigurumi penguins, amigurumi giraffes, amigurumi llama, amigurumi pigs, amigurumi bunny, amigurumi clowns, amigurumi lambs, amigurumi bees, amigurumi unicorns, amigurumi dolls, amigurumi foxes, amigurumi penguins, amigurumi dinosaurs, amigurumi elephants, amigurumi hippos, amigurumi monkeys, amigurumi cats, amigurumi dogs and more …
Todays daily new amigurumi free crochet pattern is Amigurumi Rose the Rabbit.
I want to give you some informations about this pattern ;
Supplies
– 3.5mm (E) hook
– 15mm safety eyes
– Yarn needle
– Fiber fill
– Disappearing ink marker
Yarn (acrylic, weight 4)
– Pink (I used Red Heart Super Saver – Baby Pink)
– Cream (I used Red Heart Super Saver – Aran)
– Tan (I used Red Heart Super Saver – Buff)
Abbreviations
sc: single crochet
inc: 2sc increase
dec: invisible decrease
ch: chain
BLO: back loop only
slst: slip stitch
Attaching with thread vs. yarn tail
For a cleaner look on the belly patch, I opted to weave the tail into the back of the work and trim it short, then attach the belly patch to the body with a sewing needle and matching thread.
Stitch markers
?How to attach the tip of the nose to the snout
Note: The photos above show a raccoon, but the technique is the same for all of my patterns.
Step 1 – Cut a strand of yarn approximately 18″ long. Tie a large, secure knot in one end and thread the other end through your yarn needle.
Step 2 – Insert your needle through the back opening of the head and exit the needle through the starting magic ring on the snout.
Step 3 – Next, thread your needle through the starting magic ring of the nose, then insert your needle back through the starting magic ring on the snout.
Step 4 – Flip the head over. Secure the two black strands with a large knot on the inside of the snout, then trim the excess.
Step 1 – Close the top opening of each ear with a slip stitch, leaving a long yarn tail.
Step 2 – Fold the slip-stitched edge in half and sew closed with a running stitch using your yarn tail and a yarn needle, leaving the tail intact.
Step 3 – Your ears should now look like figure 3 above and are ready to attach to the head at a later step!
Step 1 – Line up your ear with your color 3 stitch marker on the top of the head.
Step 2 – Using a yarn needle and your yarn tail, attach the ear to the head stitch-for-stitch, leaving your stitches slightly loose in case you need to undo them. Repeat steps 1 and 2 for the second ear.
Step 3 – Examine the head from multiple angles to make sure your ears are symmetrical and look the way you want them, then remove your stitch markers. Tighten down your stitches, secure the end with a knot, and hide the yarn tail inside the head.
Instructions
Be sure to read the “notes” section before proceeding.
Nose
With pink yarn:
01. start 6 sc into a magic ring [6]
02. *sc, inc* [9]
03. *sc 2, inc* [12]
Switch to tan yarn (tutorial):
04 – 05. sc in each st around [12]
06. sc 11, inc [13]
07. sc in each st around [13]
08. sc 6, inc, sc 6 [14]
Fasten off and leave a long tail for sewing. Fold the top opening in half and slip stitch closed.
Ears (make 2)
With tan yarn:
01. start 6 sc into a magic ring [6]
02. inc in each st around [12]
03. *sc 3, inc* [15]
04. sc 2, inc, *sc 4, inc* 2 times, sc 2 [18]
05. *sc 5, inc* [21]
06. sc 3, inc, *sc 6, inc* 2 times, sc 3 [24]
07. *sc 7, inc* [27]
08. sc 4, inc, *sc 8, inc* 2 times, sc 4 [30]
09 – 11. sc in each st around [30]
12. sc 14, dec, sc 14 [29]
13. sc 27, dec [28]
14. sc 13, dec, sc 13 [27]
15. sc 25, dec [26]
16. sc 12, dec, sc 12 [25]
17. sc 23, dec [24]
18. sc 11, dec, sc 11 [23]
19. sc 21, dec [22]
Fasten off and leave a long tail for sewing. Next, follow the steps under “How fold the ears and sew them closed” in the notes section.
Snout & Head
With cream yarn:
01. Chain 3 start: ch3, inc in 2nd ch from hook, 5sc in the last ch. Continue on the other side of the chain base, 3sc in the last ch [10]
02. inc, sc 2, *inc* 3 times, sc 2, *inc* 2 times [16]
03. inc, sc 4, *inc* 2 times, sc, inc, sc 4, *inc* 2 times, sc [22]
04. inc, sc 6, *inc, sc* 2 times, inc, sc 6, *inc, sc* 2 times [28]
05. *sc 13, inc* [30]
06 – 08. sc in each st around [30]
Now sc 7 additional stitches. This ensures your color join will be on the bottom of the head. These stitches are not included in the stitch count for round 8 nor for round 9. Move your stitch marker to the last of the 7 additional stitches and continue on with round 9 as normal.
Switch to tan yarn (tutorial):
09. BLO: slst in each st around [30]
10. BLO: sc 2, inc, sc 4, inc, sc 4, inc and insert marker color 1 into the first stitch of the increase (15th stitch from start of round; the second stitch of the increase is the 16th stitch from start of round), *sc 4, inc* 3 times, sc 2 [36]
11. *sc 5, inc* [42]
12. sc 3, inc, *sc 6, inc* 5 times, sc 3 [48]
13. *sc 7, inc* 2 times, insert marker color 2 into the next sc (19th st from start of round), sc 6, inc, sc 7, inc, sc, insert marker color 2 into the next sc (38th st from start of round), sc 5, inc, sc 7, inc [54]
14. sc 4, inc, *sc 8, inc* 5 times, sc 4 [60]
15 – 18. sc in each st around [60]
19. sc 25, insert marker color 3 into the next sc (26th st from start of round), sc 13, insert marker color 3 into the next sc (40th st from start of round), sc 20 [60]
20 – 24. sc in each st around [60]
25. sc 4, dec, *sc 8, dec* 5 times, sc 4 [54]
26. *sc 7, dec* [48]
27. sc 3, dec, *sc 6, dec* 5 times, sc 3 [42]
28. *sc 5, dec* [36]
29. sc 2, dec, *sc 4, dec* 5 times, sc 2 [30]
Attach the nose to the snout by following the steps below:
Step 1 – See “How to attach the tip of the nose to the snout” in the notes section.;
Step 2 – See “How to attach the top of the nose to the snout” in the notes section.
Step 3 – Stuff head ¾ full and create indents for the eyes. See “How to indent the eyes” in the notes section.
Step 4 – Insert your safety eyes and secure the backings.
30. *sc 3, dec* [24]
31. sc, dec, *sc 2, dec* 5 times, sc [18]
32. *sc, dec* [12]
Finish stuffing.
33. *dec* [6]
Cut working yarn and close with an ultimate finish.
Attach the ears to the head (see “How to attach the ears to the head” in the notes section).
Belly
With cream yarn:
01. Chain 5 start: ch5, inc in 2nd ch from hook, sc 2, 5sc in the last ch. Continue on the other side of the chain base, sc 2, 3sc in the last ch [14]
02. inc, sc 4, *inc* 3 times, sc 4, *inc* 2 times [20]
03. inc, sc 6, *inc* 2 times, sc, inc, sc 6, *inc* 2 times, sc [26]
04. inc, sc 8, *inc, sc* 2 times, inc, sc 8, *inc, sc* 2 times [32]
05. inc, sc 10, inc, sc 2, inc, sc, inc, sc 10, inc, sc 2, inc, sc [38]
06. inc, sc 12, *inc, sc 2* 2 times, inc, sc 12, *inc, sc 2* 2 times [44]
07. inc, sc 14, inc, sc 3, inc, sc 2, inc, sc 14, inc, sc 3, inc, sc 2 [50]
Fasten off and leave a long tail for sewing.
Body
With tan yarn:
01. start 6 sc into a magic ring [6]
02. inc in each st around [12]
03. *sc, inc* [18]
04. sc, inc, *sc 2, inc* 5 times, sc [24]
05. *sc 3, inc* [30]
06. sc 2, inc, *sc 4, inc* 5 times, sc 2 [36]
07. *sc 5, inc* [42]
08. sc 3, inc, *sc 6, inc* 5 times, sc 3 [48]
09. *sc 7, inc* [54]
10. sc 4, inc, *sc 8, inc* 5 times, sc 4 [60]
11 – 17. sc in each st around [60]
18. sc 4, dec, *sc 8, dec* 5 times, sc 4 [54]
19. sc in each st around [54]
20. *sc 7, dec* [48]
21. sc in each st around [48]
22. sc 3, dec, *sc 6, dec* 5 times, sc 3 [42]
23 – 24. sc in each st around [42]
25. *sc 5, dec* [36]
26 – 27. sc in each st around [36]
28. sc 2, dec, *sc 4, dec* 5 times, sc 2 [30]
29 – 30. sc in each st around [30]
31. *sc 3, dec* [24]
Fasten off and leave a long tail for sewing. Stuff firmly with fiber fill. Attach the head to the body, then sew on the belly patch.
Legs (make 2)
With cream yarn:
01. start 6 sc into a magic ring [6]
02. inc in each st around [12]
03. *sc, inc* [18]
04. sc, inc, *sc 2, inc* 5 times, sc [24]
Switch to tan yarn (tutorial):
05. BLO: slst in each st around [24]
06. BLO: *sc 3, inc* [30]
07. BLO: sc in each st around [30]
08 – 10. sc in each st around [30]
11. sc 14, dec, sc 14 [29]
12. sc 27, dec [28]
13. sc 13, dec, sc 13 [27]
14. sc 25, dec [26]
15. sc 12, dec, sc 12 [25]
16. sc 23, dec [24]
17. sc 11, dec, sc 11 [23]
18. sc 21, dec [22]
19. sc 10, dec, sc 10 [21]
20. sc 19, dec [20]
21. sc 9, dec, sc 9 [19]
22. sc 17, dec [18]
23. *sc 7, dec* [16]
24. *sc 2, dec* [12]
Fasten off and leave a long tail for sewing. Stuff firmly with fiber fill, then fold the top opening in half and slip stitch closed. Finally, attach the legs to the body.
Arms (make 2)
With cream yarn:
01. start 6 sc into a magic ring [6]
02. inc in each st around [12]
03. *sc, inc* [18]
Switch to tan yarn (tutorial):
04. BLO: slst in each st around [18]
05. BLO: sc, inc, *sc 2, inc* 5 times, sc [24]
06. BLO: sc in each st around [24]
07 – 09. sc in each st around [24]
10. sc 11, dec, sc 11 [23]
11. sc in each st around [23]
12. sc 21, dec [22]
13. sc in each st around [22]
14. sc 10, dec, sc 10 [21]
15. sc in each st around [21]
16. sc 19, dec [20]
17. sc in each st around [20]
18. sc 9, dec, sc 9 [19]
19. sc in each st around [19]
20. sc 17, dec [18]
21. sc in each st around [18]
22. sc 8, dec, sc 8 [17]
23. sc in each st around [17]
24. sc 15, dec [16]
25 – 26. sc in each st around [16]
27. *sc 2, dec* [12]
Fasten off and leave a long tail for sewing. Stuff firmly with fiber fill, then fold the top opening in half and slip stitch closed. Finally, attach the arms to the body.
Tail
With cream yarn:
01. start 6 sc into a magic ring [6]
02. inc in each st around [12]
03. *sc, inc* [18]
04. sc, inc, *sc 2, inc* 5 times, sc [24]
05. *sc 3, inc* [30]
06 – 08. sc in each st around [30]
09. *sc 3, dec* [24]
10. sc, dec, *sc 2, dec* 5 times, sc [18]
11. *sc, dec* [12]
12. *sc, dec* [8]
Fasten off and leave a long tail for sewing. Stuff, then fold the top opening in half and slip stitch closed. Attach the tail to the body.
More Amigurumi Bunny Ideas: